Case Studies
We are pleased to say we are proud off every injection mould tool completed here at P&R.
In this section we demonstrate a selection of our current completed projects and highlight the difficulties and challenges that we overcome to make the part.
We believe that anything is possible and throughout the company we have a "give it a go" attitude that promises you won't get fresher ideas from any other toolmaker or injection moulding company.
We would like to think your project will end up here amongst our Case Studies.
-
Case Study 9
This part is for our own product range and the reason we decided to feature it is because it has 3 different sets of inserts that we can change on the press so we have no down time. It means basically...
-
Case Study 8
This part has a multitude of undercuts and clip parts on the inside face so to avoid sink marks.
We spent several days on the computer thickening and thinning different section...
-
Case Study 7
Not a particularly tricky tool but we included this in our studies because we completed this 4 imp construction part in 5 weeks including a tool drawing and product design. It was requi...
-
Case Study 6
We threw everything at this insert moulded liquid crystal polymer defence item.
It has four sliding cores, one up and away to release an undercut and a hot runner system. ...
-
Case Study 5
On this project we worked closely with the parts' American designer who had limited knowledge of the injection moulding process, offering advice and technical expertise to ensure their parts were s...
